Fold and Unroll

Fold and Unroll

Fold Back Check

Fold Back Check

Fold and Unroll

Folds the flat pieces of Unroll Surface or Triangle-Strip Unroll back into the 3D form, carrying every engraved name and joint number along, so a net can be checked before it is cut. Each piece is folded facet by facet about its fold lines (the angles come from the form, the facet shapes from the flat sheet) and then placed as a whole. Checks: every joint number must appear on two edges that meet after folding (green = they meet, red = gap or length mismatch, orange = the number appears only once, magenta = two pieces meet there but the edge has no number), every facet must keep its size and, with Target connected, the folded result must sit on the original form. Fold 0 = flat sheet, 1 = assembled; Explode pulls the assembled pieces apart. Report says PASS or CHECK with the numbers behind it.

Docs for v0.6.6, the latest version.

ID

fold-and-unroll-fold-and-unroll-fold-back-check

Group

Fold and Unroll

Keywords

fold
fold back
check
assemble
joint
number
net
unroll
verify
preview
explode
5 inputs, 5 outputs

Ports

Inputs

5

What the node takes in, from wires or typed values.

Pieces

Geometry

The Pieces output of Unroll Surface or Triangle-Strip Unroll (each piece carries its fold data)

Fold

Number

Default 1

0 = flat sheet, 1 = folded into the form

Explode

Number

Default 0

Pulls the assembled pieces apart from the centre (0 - 2)

Target

Geometry

Optional: the original form, to measure how far the folded result lies from it

Bend Lines

Boolean

Default true

Show the blue lines where the sheet bends between facets in Edges (off = outlines only)

Outputs

5

What the node gives out, to wire into other nodes.

Assembled

Surface

The facets folded into place, coloured per piece

Edges

Curve

Cut outlines (red) and, with Bend Lines on, the lines where the sheet bends between facets (blue) of the folded pieces

Labels

Curve

Engraved names and numbers, carried onto the folded pieces

Joints

Curve

Joint edges: green meet, red gap or length mismatch, orange number only once, magenta meeting edge without a number

Report

String

PASS or CHECK, with the joint counts, gaps, facet size change and distance from the form

This node has no documentation beyond its description and ports yet.

History

First documented in v0.6.5

Nov 20, 2026

Versions before it were published before changes were recorded.